Android Push Configuration

Basic Configuration

To use Push Notification in your React Native application, you need to configure Firebase into your application; refer to the following documentation to configure Push Notification in your application.

In case your application is handling the push token registration and push payload, we highly recommend you use the native Android methods(mentioned in the documentation above) for passing the token and the payload to the SDK. If, for whatever reason, you wish to pass the push token and payload to the SDK via the React component/Javascript code uses the below APIs

Passing Push Token

const ReactMoE = require('react-native-moengage')
// pass the push token as a string

Passing Push Payload

const ReactMoE = require('react-native-moengage')
// pass the push payload as a JSONObject from FCM. Note only the data payload needs to be passed to SDK.


MoEngage recommends that you use the Android native APIs for passing the push payload to the MoEngage SDK instead of the React-Native/Javascript APIs. React-Native Engine might not get initialized if the application is killed or if the notification is not sent at a high priority.

Customizing Push notification

If required the application can customize the behavior of notifications by using Native Android code (Java/Kotlin). To learn more about the customization refer to the Advanced Push Configuration documentation.Instead of extending PushMessageListener as mentioned in the above document extend PluginPushCallback.

Refer to the below documentation for Push Amp+, Push Templates, and Geofence.



Was this article helpful?
0 out of 0 found this helpful

How can we improve this article?